B0060 Code – Driver Frontal Deployment Loop Resistance High

The B0060 Diagnostic Trouble Code (DTC) indicates that the Supplemental Restraint System (SRS) has detected high resistance in the driver frontal airbag deployment loop. When the measured resistance exceeds the manufacturer's specified range, the Airbag Control Module (ACM/SDM/RCM) stores DTC B0060 and disables the driver's frontal airbag to prevent unintended deployment or deployment failure.

Important: Wire colors, connector pinouts, resistance specifications, and circuit layouts vary between vehicle manufacturers. Always compare test results with the factory service information.

Symptoms

• Airbag (SRS) warning light ON.
• Driver airbag disabled.
• SRS warning message displayed.
• B0060 stored in Airbag Control Module.

Common Causes

• Loose driver airbag connector.
• High resistance inside the clockspring.
• Corroded connector terminals.
• Damaged steering column wiring.
• Faulty driver airbag module.
• Defective Airbag Control Module.

Diagnostic Procedure

1. Scan the SRS system for all stored DTCs.
2. Inspect the steering wheel airbag connector.
3. Check the clockspring for damage.
4. Inspect wiring between the clockspring and ACM.
5. Measure deployment loop resistance according to manufacturer procedures.
6. Repair or replace faulty components.
7. Clear DTC and verify normal operation.

Responsive Signal Flow Diagram

Battery

➜

Airbag Control Module

➜

Clock Spring

➜

Driver Airbag

Responsive Wiring Diagram

       +12V
         │
         ▼
 ┌─────────────────────┐
 │ Airbag Control Unit │
 └────────┬────────────┘
          │
          │
          ▼
 ┌─────────────────────┐
 │    Clock Spring     │
 └────────┬────────────┘
          │
          │
          ▼
 ┌─────────────────────┐
 │ Driver Airbag Module│
 └─────────────────────┘

Recommended Repairs

• Repair damaged wiring.
• Replace a faulty clockspring.
• Clean or replace corroded connectors.
• Replace the driver airbag module if resistance is out of specification.
• Replace the Airbag Control Module only after confirming the circuit is fault-free.

Can You Drive With B0060?

The vehicle will usually continue to operate normally, but the driver's frontal airbag may not deploy during a collision. The fault should be repaired immediately for proper occupant protection.

Related DTCs

• B0061 – Driver Frontal Deployment Loop Resistance Low
• B0012 – Driver Frontal Deployment Loop Stage 1
• B0013 – Driver Frontal Deployment Loop Stage 2
• B0059 – Passenger Deployment Loop Resistance Low
• B0062 – Driver Deployment Loop Circuit Fault

Frequently Asked Questions

Can a bad clockspring cause B0060?

Yes. A worn or damaged clockspring is one of the most common causes of high resistance in the driver airbag circuit.

Can I erase B0060 without repairs?

No. The DTC will usually return until the high-resistance condition has been corrected.

Is B0060 a serious fault?

Yes. The driver's frontal airbag may be disabled, reducing protection in a frontal collision.